Search results for "Short circuit"
showing 10 items of 39 documents
Modeling Stator Winding Inter-Turn Short Circuit Faults in PMSMs including Cross Effects
2020
Author's accepted manuscript. © 2020 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works. This paper presents a detailed analysis of stator winding inter-turn Short Circuit (ITSC) faults, taking the cross effects in the three phases of a permanent magnet synchronous motor (PMSM) into account by considering insulation degradation resistances. A PMSM with series coils in eac…
Fabrication and characterization of low cost Cu 2 O/ZnO:Al solar cells for sustainable photovoltaics with earth abundant materials
2016
Abstract The low cost electrodeposition method was used to grow Cu2O thin films and experimentally determine the optimal absorber layer thickness. Raman scattering studies indicate the presence of solely crystalline Cu2O and SEM images show that the thin films consist of grains with a pyramidal shape. The influence of the thickness of the light absorbing Cu2O layer on the basic characteristic of the heterojunction and their properties have been investigated using reflectivity, current–voltage (J–V), capacitance–voltage (C–V) and the external quantum efficiency (EQE) measurements. The depletion layer, the charge collection length of the minority carrier, and reflectivity are the main factors…
SiC MOSFET vs SiC/Si Cascode short circuit robustness benchmark
2019
Abstract Nowadays, MOSFET SiC semiconductors short circuit capability is a key issue. SiC/Si Cascodes are compound semiconductors that, in some aspects, show a similar MOSFET behaviour. No interlayer dielectric insulation suggests, in theory, Cascode JFETs as more robust devices. The purpose of this paper is to compare the drift and degradation of two commercial devices static parameters by exposing them to different levels of repetitive 1.5 μs short-circuit campaigns at 85% of its breakdown voltage. Short-circuit time has been set experimentally, and longer times result in catastrophic failure of MOSFET devices due to over self-heating. For this purpose, pre- and post-test short circuit ch…
A summary of expressions for central performance parameters of high efficiency solar cell concepts
2019
This work reviews expressions for central performance parameters of various types of PV-concepts when operating at the radiative limit. Some new expressions not published elsewhere are also included. The performance parameters include the short circuit current density, the open circuit voltage, the maximum power density and the optimal voltage. The cell concepts include single junction cells, cells optically coupled to up- and down-converters, intermediate band solar cells and a couple of implementations of multijunction devices. The Lambert W function is used to express the maximum power density.
A procedure to calculate the I–V characteristics of thin-film photovoltaic modules using an explicit rational form
2015
Abstract Accurate models of the electrical behaviour of photovoltaic modules are effective tools for system design. One or two diode equivalent circuits have been widely used even though some mathematical difficulties were found dealing with implicit equations. In this paper, a new model based on a simple rational function, which does not contain any implicit exponential form, is presented. The model was conceived in order to be used with thin-film photovoltaic modules, whose current–voltage curves are characterised by very smooth shapes. The parameters of the model are evaluated by means of the derivatives of the issued characteristics in the short circuit and open circuit points at standa…
Plasmonic effects of ultra-thin Mo films on hydrogenated amorphous Si photovoltaic cells
2012
We report on the improvement of short circuit current (JSC), fill factor (FF), and open circuit resistance (ROC) in hydrogenated amorphous silicon (a-Si:H) photovoltaic cells with a p-type/intrinsic/n-type structure, achieved by the addition of an ultra-thin molybdenum film between the p-type film and the transparent conductive oxide/glass substrate. For suitable conditions, improvements of ≈10% in average internal quantum efficiency and up to 5%–10% under standard illumination in JSC, FF, and ROC are observed. These are attributed to the excitation of surface plasmon polariton modes of the a-Si:H/Mo interface.
Magnetic Field and Short-Circuit Reactance Calculation of the 3-Phase Transformer with Symmetrical Amorphous Core
2006
Magnetically symmetric, 3- phase transformer has been analysed. For the two variants of the windings, the calculation results have been compared with the measured ones. Magnetic flux density components were calculated in and out of the core. The flux distribution and short-circuit reactance have been verified experimentally and a good agreement has been obtained.
Organoboron Polymers for Photovoltaic Bulk Heterojunctions
2010
We report on the application of three-coordinate organoboron polymers, inherently strong electron acceptors, in flexible photovoltaic (PV) cells. Poly[(1,4-divinylenephenylene)(2,4,6-triisopropylphenylborane)] (PDB) has been blended with poly(3-hexylthiophene-2,5-diyl) (P3HT) to form a thin film bulk heterojunction (BHJ) on PET/ITO substrates. Morphology may be modulated to give a high percentage of domains (10-20 nm in size) allowing exciton separation. The photoelectric properties of the BHJs in devices with aluminium back electrodes were imaged by light beam induced current (LBIC) and light beam induced voltage (LBIV) techniques. Open circuit voltages, short circuit currents and overall …
Electro-optical characterization of ruthenium-based dye sensitized solar cells: A study of light soaking, ageing and temperature effects
2017
Abstract In this work, we report on the electro-optical characterization of Dye Sensitized Solar Cells (DSSCs) which use ruthenium complexes as sensitizers. In particular, several kinds of measurements have been performed to study the electrical performances and the efficiency levels of the cells at different operating conditions. In detail, the measurements have been conducted at varying temperatures and hours of light soaking. Our results show that the short circuit current density J SC , the open circuit voltage V OC and the conversion efficiency η increase with the hours of light soaking, while they decrease with temperature. A thorough investigation on the light soaking process at the …
Electrical and photoelectrical measurements on ZnO-Nanowires coated with PEDOT:PSS for Dye-Sensitized Solar Cells
2011
ABSTRACTDye-sensitized solar cells composed of an n-doped ZnO nanowire array and a p-doped polymer layer appears to be a promising candidate for low-cost production of environment-friendly solar cells. In this work, we investigate hybrid devices consisting of a transparent conducting oxide (TCO) substrate, ZnO-nanowires (ZnO-NW) or a sol-gel prepared ZnO layer, a ruthenium dye (N719) and a PEDOT:PSS or P3HT layer. The dense polycrystalline ZnO layer is able to prevent short circuits, which have a strong effect on the performance of the solar cells. This is demonstrated by the use of only the ZnO layer which improves the open circuit voltage by a factor of 2 and the efficiency by a factor of…